Wireless

Good Morning world! I have a question in regards to how Cisco Flex connect works. Currently we are experiencing an issue with certain clients (iPads in guided mode) dont seem to be working weell when our AP's move from Connected > Standalone > Connec...

 Hi,End user has a WLC AIR-CT5508-50-K9 with ver 7.5.102.0 with 17 LAPs registered ; 9 LAPs are registered in the main site the other 8 LAPs registered in the remote site; the problem is that WLC's logs show many alarms like: - Impersonation of AP wi...

I have been tring to build a bridge with a 1262 on one end a 2602 on the other and not having any luck connecting. The 2602 replaced a damaged 1262. I only use the A radio for the bridge. Any suggestions on the config?

Hi, I have 100Mbps Internet Bandwidth connection. when I Perform speedIn wired-- >100 MbpsIn wireless client--> 20 mbpsAccess points used is Autonomous N-series access point. whcih has to support upto 300 Mbps.I have done iperf testing also.There als...

Hello Can someone explain to me how a gig switchport on a Cisco 5508 controller is different than an Gi0/0 interface on an ASA5515x?Both interfaces are on same vlan.Both interfaces show up/up    Cables have been swapped.    Ports have been changed.  ...

I'm not sure about how broadcasts are handled in a centrally-switched (not FlexConnect) environment. Our network has large /22 networks for wireless users...in a traditional wired world, that's a big broadcast domain. Add multiple /22 networks in an ...

For our branch offices’s wireless access, we would like to use FlexConnect with one SSID and two distinct user profiles:•  Full network access, local switched.•  Limited network access, central switched:◦       To isolate traffic from the branch’s LA...

I have AP's in Flexconnect Mode doing local switching, central auth.  For a particular WLAN, we are using mac-filtering.  When creating the local mac filter, should we select none under interface name where you would normally map the interface for th...

Hi, I have a Cisco Wireless LAN Controller with 51 access points, model 2601. And I would like to buy the Cisco Prime Infraestructure 2.0, I have doubts about the Lifecycle License, how many lifecycle device license I need? For 52 devices (01 WLC + 5...

I have a Cisco 1242 AP with patch antenna attached(ANT2485P-R...2.4Ghz, 8.5dBi) placed on a wall that it directed down a long isle. From the wall to the end of the isle is almost 200 feet. I need reception to run RF guns that scan codes off material ...

HiWe have AIR-CAP1532E-E-K9 and these are registered to wlan controller but their operational status is down. What can be the cause?(Cisco Controller) >show sysinfoManufacturer's Name.............................. Cisco Systems Inc.Product Name.........

Dear Experts,I will be  implementing the design as per the attached diagram. The two sites are around 500 meters apart and are connected through an access port ( not trunk). They cannot be put in trunk as the client will not allow us to. Please refer...