07-12-2008 08:35 AM - edited 07-03-2021 04:09 PM
Hi,
Just starting out with our new 2106 controller and 3 1252's. I have PoE injectors on the AP's (AIR-PWRINJ4), but I get the same problem if I plug in to the WLC ( i know its not enough power, just trying it out).
All I seem to get are all lights flashing on 2 of the AP's I have tried. The closest diagnostic I can pull out of the troubleshooting table online is that there isn't enough power. The lights are as follows:
Ethernet blinking Green
Status Blinks green, blue, red (power issue?)
Radio blinks amber
Again, there really isn't a chart that says what this problem could be, I am just going off of the status code. I logged in the console and ran debug lwapp events enable and see nothing...
Thanks,
07-12-2008 11:24 AM
Well for one, the power injector you are using is correct for the 1252. That will power both radios up. The problem you see is the LAP not joining the wlc. You have to configure the 2106 and then have the 1252 join the wlc and you will be good to go.
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080665cdf.shtml
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml
http://www.cisco.com/en/US/docs/wireless/technology/poe/technical/reference/Power.html#wp45170
07-13-2008 05:00 PM
Hi,
Thanks for the response. Turns out for some reaosn, all the changes I had been saving didn't I chagned them all back and rebboted the controller and all is well!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide