Hi,I have Pix 525(pix722.bin), when iam trying to access some applicaton using X-manger ,iam getting disconnected frequently (normally when the connection is ideal) .how can i increase the xdmcp time out values in pix?Thanks in advance Dinesh
Hi,I hope someone could give me a hint on this problem...our wireless clients are experiencing high ping times when pinging eachother. around 20-50ms. they are close to the LAP and associated to the same LAP. Ping times from a wireless client to the ...
I am trying to use the Assisted Site Survey on our WLSE Express. I can get to the point where I can do my Walkabout with the client and gather data. Upon doing the client walkabout I can 'never' gather any data.Any Thoughts?I have even purchased a ...
I have a 1510 I just got back from a RMA and when we put it on the network it will connect and work then a couple hours later it will no longer show on the controller. Any ideas?
Hi Community!We are going to deploy working enviroment with all wireless,through WCS,LWAPP 1252G-E-K9.Is it stable in working?We have 5 warehouse,do we have a tool kit for effective survey at these places?
Hi!We've 36 cisco lightweight access-points. After typing "show cdp neighbours" on switch they all are connected, I see: Port Device-ID Port-ID Platform-------- ------------------------------- ------------...
We have two 4402 WLAN Controllers and a number of 1131 LWAPP's spread throughout our campus. Is is possible to set up a WLAN (SSID) that is only available on certain access points? We have some of these access points in apartments in the surroundin...
Hi,Im new to cisco wlc, but have been working a lot with hp procurve WESM.Im the procurve you can easily choose a custom logo to be displayed to the web guests when logging on.Can this be done on the WLC 4400 with software 4.1x?
I have a WLC 4402 and WCS with a total of 10 WLANS. About half aren't broadcasted. At certain sites i have only 1 or 2 WLANS broadcasted by using the WLAN Override function and it is working. I added a couple more AP's at a new site and i can't get t...
Does anyone know if I can pass parameters to the Upgrade tool so I don't have to type in the same information every time I run it? Especially since you have to close and re-run it each time due to Cisco documented memory leaks!! I have 300 1120s to...
DHCP Clients are getting IPs from a windows based dhcp server without issue however the wlc is setting itself as the gateway address. When this happens no traffic flows as the controller is not doing any routing. Is this how it should be or is someth...
I have old handheld devices that are using LEAP authentication to a local radius server. They are currently connected to IOS based access points. I am trying to convert the site to controllers /lwapp, but I cannotget LEAP to work through the contr...
Hi,we use WLSE Express 2.15 with the AAA Server and a configuered Windows Domain Auth Server. At the Access Point's (WDS-AP) is the WLSE as radius server configured.PEAP works fine in this constellation. But when the Windows AD Server or the Service ...
I am implementing WCS (LightWeight Access Point) and plan to point the log to external log using linux box syslog (Fedora). Is it possible? because have been trying a couple days ago seemingly is not able to log to external log. Note: my current sys...
