No Access/Connection AIR CAP1532i-E-K9 - no Console output First Time Configuration

[sven.grund.axsysnet]

Hello,

i want to configure an Access Point AIR CAP15321i-E-K9 for the first time and with no Controller.

The Access Point is connected to a POE Cisco SG50 Switch .

I can ping the AP (DHCP IP) , but i don`t get the GUI or a Console Output .

The LED is blinking green.

If there any POE Settings or a special Console Cable or something else i have to use/do ?

Thank for Help

[Divya]

Hi,

CAPWAP APs does not have remote session(SSH/Telnet/HTTPS/HTTP) support by default.

The only way to access the AP is through Console cable. If you don't have a WLC in the network then you need to convert this AP to Mobility Express so that you can manage as well as serve the wireless clients.

Regards,

Divya

[Divya]

Refer this link for the step-by-step process of CAPWAP to ME conversion:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_Mobility_Express_Deployment_guide/b_Mobility_Express_Deployment_guide_chapter_01100.html#task_7B18649C99D94D2BB551EDDEB16B6601 

Regards,

Divya

[sven.grund.axsysnet]

Hello,

thank you for reply.

Can i download a version of Mobility Expess without Service Contract or must i have a service contract ?

Because i get the message that a service contract is required when i want to download Mobility Express.

Thank you.

[Divya]

Please provide me your CCO id and I'll publish the image to you.

Regards,

Divya

[sven.grund.axsysnet]

Hello,

Sven Grund

sven.grund.axsysnet

sven.grund@axsysnet.de

Thank you

[Divya]

My Bad!

I thought it is AP1832 model :(

AP1532 supports Autonomous mode and it is very simple to convert. Please follow the below steps:

AP#capwap ap autonomous
Convert to Autonomous image. Proceed? (yes/[no]):

[sven.grund.axsysnet]

Hello,

thank you.

I don´t get an output on the Console/Serial Port only a black screen.

Must i do special Settings or use a special ConsoleCable ?