No Such Object available on this agent at this OID

[Rosa Ladeira]

snmpwalk -v2c -c public AccessPoint_IP 1.3.6.1.4.1.9.9.273
Unlinked OID in IPATM-IPMC-MIB: marsMIB ::= { mib-2 57 }
Undefined identifier: mib-2 near line 18 of /usr/share/mibs/ietf/IPATM-IPMC-MIB
Bad operator (INTEGER): At line 73 in /usr/share/mibs/ietf/SNMPv2-PDU
Expected "::=" (RFC5644): At line 493 in /usr/share/mibs/iana/IANA-IPPM-METRICS-REGISTRY-MIB
Expected "{" (EOF): At line 651 in /usr/share/mibs/iana/IANA-IPPM-METRICS-REGISTRY-MIB
Bad object identifier: At line 651 in /usr/share/mibs/iana/IANA-IPPM-METRICS-REGISTRY-MIB
Bad parse of OBJECT-IDENTITY: At line 651 in /usr/share/mibs/iana/IANA-IPPM-METRICS-REGISTRY-MIB
SNMPv2-SMI::enterprises.9.9.273 = No Such Object available on this agent at this OID

Is it possible to make a MIB available ?

Can it be imported to access point?

Thanks in advance

Rosa

[Claudio Gonzalez Sequeira]

Hi Rosa, 

as you know there are two types of access points, if this is Lightweight you can't do a snmpwalk directly you need to do it to the controller, but if this is Autonomous you can do it. However,  you can't import any OID/MIB they come within the ios image. 

you can check the supported images for  CISCO-DOT11-ASSOCIATION-MIB in the following link :

http://tools.cisco.com/ITDIT/MIBS/AdvancedSearch?MibSel=250297

Hope it helps!

Claudio Gonzalez