01-17-2017 04:10 PM - edited 07-05-2021 06:23 AM
Ok, maybe this is simple issue or a limitation, I have a 5508 wireless controller that is only used for home users with OEAP access points. When using a OEAP 600 we can chain the phone and pc on the same port with no issue, on a OEAP 1810 the phone goes on port 1 and the PC on port 2 and if we chain the phone and PC the PC will get a corporate IP but the phone will get a 10.0.0.x IP.
I don't see any options in the 5508 to make a difference in this situation, I am wondering if there is a setting on the phone that needs to be set differently through call manager to allow the PC port and the Phone to get a corporate IP?
Sorry if that didn't make sense, I hope it did.
-Terry
01-17-2017 04:11 PM
I should mention that on the 1810 OEAP if the phone is on port 1 and pc on port 2, they both get a corporate IP and work fine, maybe it is a limitation of the 1810?
01-17-2017 06:49 PM
I noticed recent release note update stating "multiple clients on wired" port as not supported feature for 1810 & 1810W.
Refer table 9 on below release notes
http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn83.html#45212
HTH
Rasika
*** Pls rate all useful responses ***
01-23-2017 11:44 AM
I never picked up on that Rasika. The 602i allows you to have a switch plugged into the rlan and serve up to 5 devices. Hopefully this is not a hardware limitation and a software feature will be introduced allowing multiple devices off 1 port.
01-17-2017 04:26 PM
Hi Terry,
Did you follow the below
HTH
Rasika
*** Pls rate all useful responses ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide