cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
653
Views
0
Helpful
1
Replies

OfficeExtend Access Point 600 series

Tree1964
Level 1
Level 1

I reset OfficeExtend AP 602i to factory default.  Now when I connect it to the network it does not pull an IP Address via DHCP.   I need the IP address in order to reach it to finish configurations........   Insight / Suggestions?

 

Thanks

1 Reply 1

marce1000
VIP
VIP

 

 1) Check DHCP server logs, if not yet done 2) Check the boot process through the console of the AP (fully) ; watch for any abnormal behavior during the boot-cycle.

M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card