Option 43 and CNR 6.2.3.1

[sdbrockme]

I'm having a hard time setting up option 43. The standard command in nrcmd gives the following output.

nrcmd> vendor-option

322 Feature not supported - incompatible cluster version

nrcmd> vendor-option

322 Feature not supported - incompatible cluster version

nrcmd> help vendor-option

500 - cannot open help file /opt/nwreg2/local/docs/nrcmd/vendor-option.txt

It doesn't look like vendor-option even exists on this version. It looks like the command is now 'option'.

Anybody got any ideas.

[andrew.prince]

You would normally add option 43 in the ip DHCP pool configuration, supply the rest of your DHCP config?

[kevin_miller]

Did you figure this out?? I've got the same issue. Thanks!

[lfabricio]

Hi sdbrockme,

Try the command option-set rather than vendor-option, like the example below:

nrcmd> option-set aironet1200 create 8-bit vendor-option-string="Cisco AP c1200"

100 Ok

Regards,

Leandro Oliveira