HI guys
Hope you well
I have a problem with a site, simple problem but becoming an issue.
I have to change the ip address or the lwapp1142 to static but it refuses to take the ip address and keeps getting the Dhcp address.
The address i would like it to use is of the same managment Ip adddress of that of the controller.
what I did notice is that when setting up the 5508 compared to the 4400 controller
we all know that the 5508 uses Capwap and the older code used LWAPP.
In setup of the controller i saw the step that normally says AP manager interface is not there anymore it just asked for managment and the normal interfaces like service ,Virtual etc
in my understanding that Ap manager ip address normaly makes the Ap associate with WLC since on bootup of the AP so it can do so to download the image.
can th problem be that teh network guys are using dhcp option 150 rather then 43 where the Ap keeps getting the data vlan ip address? or is teh above a problem
I have also consoled into the ap and physically tried setting it to manual and takes it then reboots and gets dhcp again
This is very important to sort out since our Gnoc cannot monitor the devices
Please guys your input will be much apprciated
Thanks
Thags Govender
mail me at thags.govender|@hp.com