Wireless

Does anyone have any other method of staging/priming their Cisco 1552 mesh access points?  I have four to work with for a pilot, but they did not come with bench power supplies or power cords.  They'll power up with 802.3af power, and even a power in...

I am experience multiple clients dropping at the same time off of AIR-LAP1252AG-A-K9 access points when the client count is over 20 clients.Is anybody else experiencing this? Is there a client count limitation on the 1252? I don't recall seeing that ...

i did outdoor Survey & AP was able to reach distance 200 Meter with Signal strength as good on laptop ( -65dbm )a colleague told me that theoritically a client ( laptop ) cannot be far from AP more then 15 M as it will get signal but will not be able...

Hi AllDoes the 8500 support any SMOF SFPs? data sheet only talks about a MM based SFP.ThanksJ

Hi EveryoneJust deploying PI 1.2 for a new wireless network, in a new building. Does anyone know if:1. You can import floor plans with structural information about the walls etc directly into Prime maps.2. How do you do it.3. What sort of diagrams do...

Hello everyoneRunning vwlc 7.3.101 and encountered a smaller issue.When you enable / disable a SSID, all AP's reset their radio interfaces... causing everyone to drop their connection.Is this intentional?Thanks

This is a pretty cheesy question compared to some, but an annoying one.  I have a very nice and detailed floor plan of one of our Hospitals, however, PI's zooming ability in comparison to WCS/NCS is um.. lacking.  Anyway to up the zooming ability in ...

Hello,I`m having some problems importing autocad files to my floor plans in wcs 4.2. I keep getting the following error message: "Error in geting data from server. Make sure you have connectivity and the server is UP".

When I am trying to import a CAD into WCS 5.0.56.0 and I keep getting a communication error from the server and the CAD will not import. Anyone heard of this?

Hi everyone,I got a situation. We had our wireless mesh network running with 4400 Controller and 1510 A.Ps. Now that we have bought new 5508 Controller (with SW: 7.2) and 3600 Indoor APs, we are unable to add legacy APs on our new controller. After a...

Hi all,can someone explain how to configure anchoring on a 'remote lan' wlan for the OE-solution?That's my setup:- DMZ:2504-CTR with code 7.3.101.0- Internal5508-CTR with code 7.3.101.0I've configured two WLAN's and anchored it to the internal Contro...

Hello,I have a problem configuring ClientLink on a FlexConnect local switching AP (3602i), the problem is that I can not see the clients that are using the ClientLink feature when entering the show interface dot11radio 1 lbf rbf command, the AP shows...