10-19-2023 01:35 AM
Hello everyone.
We have Cisco access points installed in our administration. Initially, we connected the access points to the Cisco switches, and then we connected the Cisco switch to the Mikrotech router. However, we are currently facing an issue where the access points only connect to mobile phones and allow sharing, but they do not work or connect to computers after a few minutes. Although they are physically connected to the computers, they do not function properly. Whenever we restart the access points, they work for a few minutes and then stop working again.
AP model: AIR-CAP3702l-A-K9
Solved! Go to Solution.
10-24-2023 10:41 AM
I've already shared the link to the IOS above twice before ^^^^^
And you must have already downloaded it if you were installing it right? (because you said "When I was installing the firmware to AP")
10-24-2023 11:41 PM
Thank you, a lot.
I appreciate you.
10-25-2023 08:31 AM - edited 10-25-2023 08:35 AM
Hello dear
I have tried to recover AP ROMMON using this method, but unfortunately it did not work. I kindly request your guidance and assistance.
Note: I used tftp32 unfortunately the same problem
I have shared screenshots
10-26-2023 01:57 AM
It looks like you got to the beginning of step 5 (tftp_init) and then repeated that a few times even though you only need to enter that once (why?)
Did you continue with the rest of the steps to initiate the file transfer?
10-27-2023 04:07 AM
I tried many ways and besides that, I got any information from Google, but I didn't find it.
10-27-2023 04:28 AM
But you did not even follow the instructions provided and did not answer my question about why you never went past tftp_init in the steps!
I think you need to hire a Cisco networking specialist to do this for you as they will be able to understand and follow the instructions.
While they do it you can watch and take notes for the next time in case you want to try to do it yourself.
11-05-2023 05:38 AM
Hi
When I install this IOS file: (ap3g2-k9w7-tar.153-3.JBB5) works but does not work without JBB like those (ap3g2-k9w7-tar.153-3.JPO), (ap3g2-k9w8-tar.153-3.JPQ) when installed it after GUI no work.
What's the issue?
11-06-2023 01:09 AM - edited 11-06-2023 01:11 AM
Use whichever you are happiest with.
There are known issues with the GUI which will never be fixed.
Cisco stopped development, testing and fixes on that years ago.
It would useful for you to use and understand the command line IOS config, then you won't need to use the GUI.
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide