03-21-2017
09:48 AM
- last edited on
07-05-2021
06:43 AM
by
cc_security_lab
Some of Cisco AIR-CAP3702I-A-K9 access points at PoE status shows "PoE/Medium Power (15.4 W)". Other access points at PoE status shows "PoE/Full Power" on the same Cisco switch.
PoE switch is Catalyst WS-C4510R+E with dual power supply 6000W/each.
Any thoughts on this situation. Thanks,
03-21-2017 02:31 PM
If they are connected to the switch, then post the complete output to the command "sh power inline | i AIR".
03-23-2017 03:58 AM
Are they all connected to the same linecard? Some support PoE+ and can supply the 18W or so that's preferable to the 3702 and other AP's.
If they can't allocate that, they will fall back, but run fewer internal radios and drop a spatial stream if only the 15.4w is available.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: