Hello friends. I have several AIR-AP1852I-E-K9 and AIR-AP1562E-E-K9 administered centrally in a controller which is configured in one of the AIR-AP1852I-E-K9. Specifically the AIR-AP1562E-E-K9 are attached with two AIR-ANT2547VG-N antennas connected connected at port 1 and 2 respectively.
For the Outdoor AP, they are located in open areas. The biggest challenge is very weak signal transmission. Signals are received within 1Metre from the AP, Beyond that devices does not receive any signal. The channels have been set to Auto selection
