Hello,
I have existing AP configuration on my network with AP1130AG-E-K9. My configuration is based on hidden SSID with WPA TKIP passphrase.
I have Motorola Symbol connected on this SSID. To connect this device i have set "power client local" on each Dot11radio.
Recently a bought SAP1602E with external antenna (ANT2524DW-R) to enable wireless in a warehouse.
"Power client local" don't stay after reboot AP.
I tried to enable-disable "aironet extention" and applied antenna gain to 2 and 4 on dot11radio by telnet and web management, but it's the same things.
this is my configuration:
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
encryption vlan 1 mode ciphers tkip
!
ssid SSID
!
antenna gain 2
stbc
beamform ofdm
station-role root
!
interface Dot11Radio0.1
encapsulation dot1Q 1 native
no ip route-cache
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Dot11Radio1
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
encryption vlan 1 mode ciphers tkip
!
ssid SSID
!
antenna gain 4
no dfs band block
stbc
beamform ofdm
channel dfs
station-role root
!
interface Dot11Radio1.1
encapsulation dot1Q 1 native
no ip route-cache
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
Thank for help.