Wireless

Hi Have anyone experience about the selection rule? My problem is: I've two policy against the same group device: One use active dir database and PEAP method and the second use local database and eap fast (wifi phone) How I can discriminate the authe...

The general rule of thumb is 7-8 voice client per AP and 15 to 25 data clients.Has anyone seen any documentation that explains this more fullyI have seen figures higher than this for pure 802.11g environments but cant recall where and does this still...

Our new phone system has been put in place as of yesterday, how ever someone forgot to mention that we will have wireless handsets...my main issue is that i can get the phones and the pc clients to connect. The AP (1242ag configuration attached) is a...

Sorry about multiple posts, did not know which it applied to more so, anyway;Hi Guys,Basically I want to be able to have wireless users (laptops) connect to access points and authenticate them selves (most likely with a captive portal on their intern...

We have one 4402 and one WiSM in a 6513. I have been using the 4402 controllers internal DHCP to assign IP addresses to the APs. The other day we rebooted the 4402 running DHCP and started getting IP conflicts on the APs. Seems like after the reboot ...

HelloI want to know if it is possible to connect 3 x 1242G's (non-bridge) to one 1242G (bridge)? The Root-Bridge (Main AP, connected to our LAN with the router) has an omni-directional antenna, the 3 other 1242G's will connect to this one with direct...

Hi If there is no VLAN defined for SSID, is it going to use default VLAN as the same with AP VLAN?ThanksSAi

Hi Guys,Basically I want to be able to have wireless users (laptops) connect to access points and authenticate them selves (most likely with a captive portal on their internet broswer software) against the Novell eDirectory server via RADIUS. Are the...

Hi, Is it straight process for downgrading OS or do I need any intermediary version ?Thanks for helping

I have a building that was implemented with 6 AP's(1130) going over 1310G bridges. I've had user complaints that the wireless is slow and found that 12.4 anything was bad IOS(buffer leaks mostly). Now I have found that the AP's are talking to the Wis...

Reading the Cisco Guest access deployment senarios again becomes a little unclear.Lets assume 3 scenarios.1 Small office4 access points1 2106 controllerThis will give simpl guest access terminate the guest vlan in an adsl router and a web auth page a...

I recently installed 10 1252's with TerraWave combined 2.4/5 Gigaherz antennas. While the coverage is great, the clients available bandwidth fluctuates greatly. Sometimes the client goes all the way to 1Mbps then bombs out. Reconnecting usually resol...

I use the cisco controller 26 series, , when i send the pod packet to it from a computer, can not get any reponse, what's up?

Hi All, This is a bit odd but it has been happening ever since we have been using the Cisco wireless APs and the 2106 Controllers. When ever the controller goes down, either through power outage or planned outage the APs lose connection and never rec...

I have WCS 5.X running with trial license until our we receive our purchased license. Our 2710 AL came in and I have it up and running and known to WCS. I have a couple getting started questions.Not sure what the https enable is for on the AL? I did ...