problem doing wlse radio scan

[jimbostan]

Hi,

Just did a radio scan of a building with 18 APs. It all went well but one AP was removed from the scan due to the following error.

ERROR: Measurement Request NAK received - removing interface 00-40-96-a1-0d-7c from AP Radio Scan participation

I've not had any luck finding and explanation for this error....where can I look it up?

....thx....J

[rmushtaq]

What type of radio interface this AP have?. Make sure that you select the correct radio type in the PHY screen of the scan and the intf is not down.

[jimbostan]

It's a 'b' radio like all the others in the building and it's interface is up. Again....is there somewhere I can look these types of error messages for myself?....thx

[rfadminfso]

Is your WDS properly linked to your WLSE. It should say : "Setting up registry keys" in the wireless services/wds in Wireless Network Manager Information.

I had the same problem also the WNM info then said authenticated. This is a confusing state. I then thought it was Ok....but it was not...

Good luck