Problem with Leap if I use Aegis Client on winCE4.2

[o-ziltener]

Hello

With Cisco PC-Card is no problem to authenticate with leap. But I am struggeling with the meetinghouse aegis client installed on Symbol MC3000 with windwos CE 4.2.

I tried with dyn. wep and ktip, but both failed with the aegis client. There is absolutely no entry in the cisco ACS.

Any input is very welcome

Oliver

[iveyr]

Try configuring the access point for open authentication with EAP. I cannot connect with an IPAQ without it configured this way.

[o-ziltener]

Yes, you are right. I found it out too.

TKIP with LEAP on windows CE 4.20 is working proper only with aegis client 2.1.4 from meetinghouse.

best regards

Oliver