Probleme Radius Local AP

[sodo_koto]

i have a switch catalyste 2950
and AP i have configred two vlan :

10 for private access (dhcp in routeur)
12 for public access (dhcp in routeur)

so when i put a vlan 10 in my AP with native vlan the dhcp works wells
and the vlan 12 don't take the IP from the routeur .

and when i put vlan 12 in my AP with native vlan the dhcp works wells
and the vlan 10 don't take the IP from the routeur .

can you please help me to resolv this probleme .

[Rasika Nayanajith]

Did you test without that secondary address on your BVI interface ?

Here is a one of my reference notes on this topic

http://mrncciew.com/2013/03/03/autonomous-ap-as-local-radius-server/

HTH

Rasika

*** Pls rate all useful responses ***

[sodo_koto]

thank you but when i try to connect with , the authentification don't pass ,

can you show me how to configured carte network for 802.X in windows .

[sodo_koto]

i have a switch catalyste 2950
and AP i have configred two vlan :

10 for private access (dhcp in routeur)
12 for public access (dhcp in routeur)

so when i put a vlan 10 in my AP with native vlan the dhcp works wells
and the vlan 12 don't take the IP from the routeur .

and when i put vlan 12 in my AP with native vlan the dhcp works wells
and the vlan 10 don't take the IP from the routeur .

can you please help me to resolv this probleme .

[Rasika Nayanajith]

Where is interface vlan 10 & 12 defined ?

I do not think 2950 would support multiple SVI & intervlan routing & may be the reason why you cannot have vlan 10 & 12 working at the same time.

Check AP connected switchprot configuration to make sure it is a trunk port with vlan 10,12 allowed.

HTH

Rasika

*** pls rate all useful responses ***

[sodo_koto]

configuration in port switch is trunk allowed all vlan .