"Apply" Button After Config Change Doesn't Do Anything WLC 2504

[netops009]

Hi.

After I try to create a new interface on our wireless LAN controller and click the "Apply" button it just sits there and does nothing.  The "Apply" button then has a thin blue line around it.  It totally disallows me to create the new interface.  It won't save my configuration at all.

Why is this?  

Thank you,

Thomas Reiling

[Ric Beeching]

Can you try creating it via the CLI and see if there is an output message? What account are you using to try and create the interface, a local admin account on the WLC? Do you have sufficient privileges under your TACACS account to create one?

Ric

[Sandeep Choudhary]

Change the browser and try again.

Regards

Dont forget to rate helpful posts

[u4mjac1975]

Yup... had the same issue .... was using Firefox, some of the pages were not rendering correctly and unable to "apply" changes...Switching to Chrome seemed to fix this (for me at any rate)  .... so second Sandeeps' suggestion.