Radio Transmit Power Control (TPC) Settings - Power Threshold.

[Jozef Staruch]

Hi All

I would like to know your opinion about following :

After upgrading software of WISM1 from 5.2.157 to 7.0.235.

The RRM / TCP value I have naturally adjusted for best possible radio field

I was just surprised, that I had to change the TPC  Power Threshold  value to -60 dbm, to get to the same radio field before the software update.

I am curios if value --60dBm can be problem ( hot radio field ). Maybe you know something about some problem with the "Power Level Assignment " after software update,

Thank you for updates

[Scott Fella]

I never go that hot. I have been fine with the default -70. Your basically only allowing the WLC to reduce power if an AP hears a third AP at -60.

Sent from Cisco Technical Support iPhone App

[Jozef Staruch]

Do you think it can be problem in futrue?

Since range is from -80 to 50  it should be ok , correct

[Scott Fella]

Well, like I said, I don't set it that hot.  The third ap has to be heard at -60 in order for the algorithm to happen.  All I can say is to monitor the channel and if they look fine to you , then setting that is fine.  The range is just stating that these are the values you can use, doesn't mean its okay.  You just have to see.  With -60, you probobly will not be seeing too many changes.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"