redundant WiSM configuration

[jcowtan]

I am installing a second WiSM blade on a redundant (backup)6509. The A&B side of the produciton WiSM were spec'd to run <= 300 APs.

How does one configure these control units so that production runs on WiSM blade 1 and fails over to WiSM blade 2 on the redundant 6509?

[Rob Huffman]

Hi Jon,

Have a look at this doc, it is not specifically written for the WiSM but does contain this note;

WLAN Controller Failover for Lightweight Access Points Configuration Example

**This configuration works with any other Cisco WLC and any lightweight AP.**

From this doc;

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008064a294.shtml

Hope this helps!

Rob

Please remember to rate helpful posts........