03-15-2012 07:44 AM - edited 07-03-2021 09:47 PM
Does anyone know of a way or place that the AP Failover setting on the AP is reported in WCS. I can't seem to find anywhere this setting appears in any inventory report. The only way I seem to be able to look this up is to go AP by AP and look at the config screen.
Thanks for any guidence.
JC
03-25-2012 10:39 AM
I want to be clear to make sure I understand. You want to know if there is a report in WCS if an AP fails over?
03-27-2012 06:56 AM
If you go to each AP you can set the priority level of that particular AP. I would like to be able to run a report of AP's and have part of the output of the report a listing of the AP's priority level. I can't seem to find any report that collects this field and was wondering if there was a way to report on the priority level outside of going to each AP 1 at a time.
JC
08-14-2012 08:48 PM
Rats! I was just about to ask the same thing. Sorry to see that there were no answers to the original post.
(Will it bump this question up if I ask again here, or will I need repost the whole question to get new answers?)
Basically, I'd like a Monitor screen or a report that gives a table with each AP and its failover setting. I have only 75 APs, on a -25 and -50 4402. I think I've set my favorite 25 APs to "High", and then then next most important 25 to "Medium" and then the rest should be low. That way, if either my -25 or -50 WLC fails, I still have the best coverage possible.
But, I can't find any way to easily check these settings, except by individually selecting each AP one by one from the Configure>Access Points table.
This is tedious even on my small system, and I can't imagine it would be any fun at all on a bigger one. (Maybe those big systems have full redundancy so the failover is not an issue?)
Thanks for any insights,
Steve
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide