Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
932
Views
0
Helpful
1
Replies

Restart AP using SNMP

Scott Pickles
Level 4
Level 4

‎04-02-2008 08:25 PM - edited ‎07-03-2021 03:38 PM

Does anyone know the SNMP command to send a reset to an AP? model 1240/1130 would be preferred.

Thanks,

Scott

Labels:
0 Helpful
1 Reply 1

Pushkar Sambhoos
Level 1
Level 1

‎04-02-2008 11:20 PM

Scott,

Follow the procedure listed at the URL below to reboot the AP using SNMP.

http://www.cisco.com/en/US/customer/tech/tk648/tk362/technologies_q_and_a_item09186a00800c263d.shtml#qa4

The 1130 and 1240 both support the OLD-CISCO-TS-MIB and you should be able to use the procedure listed above.

--

Pushkar

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card