10-09-2014 09:16 PM - edited 07-05-2021 01:41 AM
Hi everyone
I have a WLC 5508 and 4402
when I try to add this two into one RF grouping I get this:
Controller NameIP Address 10.66.4.250 (Invalid IP)
the IP addresses are correct and accessible. can anyone tell me why I get this error?
Additional info:
5508 software 7.6.120.0
4408 software 7.0.240.0
they are part of the same Mobility group.
4402 does not support AC but I get this error on 802.11b/g/n band as well
5508 is set to leader but it is the same error vice-versa
can the different software version be the reason?
Solved! Go to Solution.
10-09-2014 10:24 PM
Yes, two software versions you mentioned incompatible. Below is from 7.4RRM guide (page 14). As you can see even 7.4 is only compatible with 7.2 onward for RRM
http://www.cisco.com/en/US/docs/wireless/controller/technotes/7.4/RRM_DG_74.pdf
HTH
Rasika
**** Please rate all useful responses ****
10-09-2014 10:24 PM
Yes, two software versions you mentioned incompatible. Below is from 7.4RRM guide (page 14). As you can see even 7.4 is only compatible with 7.2 onward for RRM
http://www.cisco.com/en/US/docs/wireless/controller/technotes/7.4/RRM_DG_74.pdf
HTH
Rasika
**** Please rate all useful responses ****
10-09-2014 10:28 PM
As usual thanks. you are a legend.
10-09-2014 10:33 PM
You are one of my friend here in AU, so should treat you well.
I knew answer to this straight away :) as I have found it sometime back.
https://supportforums.cisco.com/discussion/12048406/rf-group-between-different-software-version
HTH
Rasika
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: