10-12-2010 12:33 PM - edited 07-03-2021 07:16 PM
Hi, how are you?.
In order to make ruting I must have a device of L3 or the WLC 5508 can do this?. I see that static route can be pointed to service port, but not another interface.
Thanks a lot.
Andres.
10-12-2010 02:20 PM
You must have another device to do the routing. Even though it has IP addresses, the WLC is a Layer 2 device only.
10-12-2010 02:25 PM
Hi Stephen, thanks for your answer. Then, WLC is only l2, but can filter ACL L3.
Thanks.
Andres.
10-12-2010 02:26 PM
Yes, because the clients traffic has to pass through the WLC.
10-12-2010 02:33 PM
Very Thanks Stephen,
My question about L3 is the following:
Each vlan is a different SSID, the efault Gateway for the clients of each one of these SSID must be an external device L3.
My question was referred to configure like default Gateway of the clients the dynamic interfaces of each one of the SSID in the WLC and from the WLC to create a route default towards another device to send all the traffic outside(internet).
Thanks a lot.
Andres.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide