Schedule WIFI using Prime 3.3.0

[torchri]

Im trying to schedule a wlan to disable and enable it again after a specific a period of time. I get an snmp error MIB access failed. SNMP Community may not have write permission, check and try again. : xxxxxxx:x.x.x.x

as image attachent shows.

I cant find where to select/input this snmp community to the task. Prime monitors the WLC properly, so Im currently stuck. Any advice?

[Haydn Andrews · Accepted solution]

when you setup the WLC in Prime did you use the RW community for SNMPv2c?

[torchri]

Thank for fast reply. This pointed me to the correct place. I see now that the the SNMP v3 user we specified in Prime only have only read permissions on WLC. I have to replace this user with a ReadWrite user who is present on the WLC. But Im a bit worried how this impact the current connection/configuration between the WLC in question and PRIME. I of course dont want to accidentially loose configuration for our maps and alarms for this controller present in PRIME. Is there any caveat here I should be aware of?