Second IP for CAPWAP Tunnel on WiSM2?

[t.erdin]

Hi all,

We have 2 WiSM2 running. Now I'd like to add some Accesspoints as OfficeExtend. As the WiSMs are in our internal network and not in the DMZ, so I thought easiest would be to create a new interface on the WiSM with a DMZ-IP which would be reachable from outside (with static NAT).

Does anyone know if this would work?

Thanks a lot

kind regards

Thomas

[Scott Fella · Accepted solution]

No... It's required to use the management IP address because that is the interface in which you have to specify the NAT address.

Sent from Cisco Technical Support iPhone App

[t.erdin]

Too bad, as his would make it much easier to separate the local network from the "remote accespoint network".

Thanks for your answer