cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1759
Views
7
Helpful
11
Replies

Skype file transfer slow on WLC

syedhashmi455
Level 1
Level 1

Hi Every one,

I am trying to transfer a file from skype over cisco WLC, but the transfer is very slow (over an hour) for a small kb of file. The same setup is running fine if I do it on local intranet.

 

I have also enabled the peer to peer blocking mode in WLC, but in vain.

Some one please help me on this as this is very urgent for me.

Regards,

SIAH

1 Accepted Solution

Accepted Solutions

The software version you are running is very very old. If WLC is 4400 or 2100 I would like you to upgrade it to 7.0.250.0.

Once you do that upgrade, then you should modify few of your WLAN settings.

- WMM should be enabled
- WPA2/AES should be enable

- WPA2/TKIP should be disable

 

Without upgrading WLC you may not able to do all required WLAN configuration.

 

HTH

Rasika

**** Pls rate all useful responses ****

View solution in original post

11 Replies 11

syedhashmi455
Level 1
Level 1

Guys, please help me on this.....I am stuck and need a quick resolution.

Are these file transfer happening two wireless end points connect two APs manged by same WLC ? If it is the case, pls attach "show client detail <mac_address>"  & "show wlan <wlan_id> outputs 

Point to Point Blocking should be "disabled" if you transfer file between two wireless clients.

HTH

Rasika

**** Pls rate all useful responses ****

Hello every one,

Attached are the results of the commands

WLAN Identifier.................................. 2

Network Name (SSID).............................. VP-Net

Status........................................... Enabled

MAC Filtering.................................... Disabled

Broadcast SSID................................... Enabled

AAA Policy Override.............................. Disabled

Number of Active Clients......................... 60

Exclusionlist Timeout............................ 60 seconds

Session Timeout.................................. Infinity

Interface........................................ vip-sps

WLAN ACL......................................... unconfigured

DHCP Server...................................... Default

Quality of Service............................... Silver (best effort)

WMM.............................................. Disabled

802.11e.......................................... Disabled

Dot11-Phone Mode (7920).......................... Disabled

Wired Protocol................................... None

IPv6 Support..................................... Disabled

Radio Policy..................................... 802.11B and 802.11G only

Security

--More-- or (q)uit

 

802.11 Authentication:........................ Open System

Static WEP Keys............................... Disabled

802.1X........................................ Disabled

Wi-Fi Protected Access (WPA1)................. Disabled

Wi-Fi Protected Access v2 (WPA2).............. Enabled

WPA Compatibility Mode:......................... Enabled

WPA2-TKIP Mode:................................. Enabled

Pre-Shared Key Mode:............................ Enabled

IP Security................................... Disabled

IP Security Passthru.......................... Disabled

Web Based Authentication...................... Disabled

Web-Passthrough............................... Disabled

Auto Anchor................................... Disabled

Cranite Passthru.............................. Disabled

Fortress Passthru............................. Disabled

 

show clinet  detail 78:6c:1c:d5:17:86

Client MAC Address............................... 78:6c:1c:d5:17:86

Client Username ................................. N/A

AP MAC Address................................... 00:1e:4a:90:39:60

Client State..................................... Associated

Wireless LAN Id.................................. 2

BSSID............................................ 00:1e:4a:90:39:61

Channel.......................................... 1

IP Address....................................... 10.16.60.170

Association Id................................... 176

Authentication Algorithm......................... Open System

Reason Code...................................... 0

Status Code...................................... 0

Session Timeout.................................. 0

Re-Authentication Timeout........................ 0

Mirroring........................................ Disabled

QoS Level........................................ Silver

Diff Serv Code Point (DSCP)...................... disabled

802.1P Priority Tag.............................. disabled

Mobility State................................... Local

Mobility Move Count.............................. 0

Security Policy Completed........................ Yes

Policy Manager State............................. RUN

--More-- or (q)uit

Policy Manager Rule Created...................... Yes

NPU Fast Fast Notified........................... Yes

Policy Type...................................... WPA2

Encryption Cipher................................ CCMP (AES)

EAP Type......................................... Unknown

Interface........................................ vip-sps

VLAN............................................. 1001

Client Capabilities:

CF Pollable................................ Not implemented

CF Poll Request............................ Not implemented

Short Preamble............................. Implemented

PBCC....................................... Not implemented

Channel Agility............................ Not implemented

Listen Interval............................ 0

Client Statistics:

Number of Bytes Received................... 997374

Number of Bytes Sent....................... 3970680

Number of Packets Received................. 8275

Number of Packets Sent..................... 4625

Number of Policy Errors.................... 0

Radio Signal Strength Indicator............ -52 dBm

Signal to Noise Ratio...................... 45 dB

Nearby AP Statistics:

--More-- or (q)uit

TxExcessiveRetries: 0

TxRetries: 0

RtsSuccessCnt: 0

RtsFailC nt: 0

TxFiltered: 0

TxRateProfile: [0,0,0,0,0,0,0,0,0,0,0,0]

ZFP_FFSW_ID_DEPT(slot 0) 548 seconds ag.... -89 dBm

ZFP_GFNW_SHFOFFIC(slot 0) 557 seconds a.... -78 dBm

ZFP_FFNW_NEAR_CGD(slot 0) 47 seconds ag.... -77 dBm

ZFP_SG_SOUTHWING(slot 0) 2275 seconds a.... -94 dBm

ZFP_SG_NORTHWING(slot 0) 548 seconds ag.... -87 dBm

ZFP_GFNW_MIS_DEPT(slot 0) 47 seconds ag.... -47 dBm

ZFP_GFNW_NEAR_SHF(slot 0) 538 seconds a.... -83 dBm

ZFP_GFNW_NEAR_DAT(slot 0) 47 seconds ag.... -76 dBm

 

Regards,

SIAH

The software version you are running is very very old. If WLC is 4400 or 2100 I would like you to upgrade it to 7.0.250.0.

Once you do that upgrade, then you should modify few of your WLAN settings.

- WMM should be enabled
- WPA2/AES should be enable

- WPA2/TKIP should be disable

 

Without upgrading WLC you may not able to do all required WLAN configuration.

 

HTH

Rasika

**** Pls rate all useful responses ****

Hello Friends,

I have just figured out some thing.

The file transfer between 2 PC's running on same SSID is very quick. Say 30MB of file is transferred on skype in less than a minute.

But if I do a file transfer from local LAN with a proxy server to a PC connected wirelessly, it takes over an hour.

The LAN has a bandwidth of 4MB and ISP side is 20MB.

Also, a PC from a different ISP is taking ages to send a file on a PC connected wirelessly in my network.

PLease share some light on this guys........Is it because of the software of WLC that is creating a problem or some thing else.

Hello,

 

as the file is taking more than one hour, so please check on the proxy server or the client it self , 

 

here is why:

1)the client signal and SNR ratio are perfect , we should ecxlude any interference or noise related issue ,

 

2)as the file take one hour so if we look into the traces we would see alot of TCP RST sent from the server , 

 

3)it should be a TCP traffic related issue with the both ends (client and server)

 

--have you tested the same senario with different client types ?

--to get the best wireless performence , test the same with open WLAN ,

--did you modified the changes that Riska suggested ?

 

 

 

No, The software upgrade is not updated. It is still running on the old one.

 

Hi,

 

Are you running 8.0 ? As their is rate limiting feature there per application (not all application) .Also if the skype is slow ..it should be for all the application.

 

Regards

Dhiresh

the software version is 3.2.195.10

Ali Aqrabawi
Cisco Employee
Cisco Employee

does these files goes through mobility tunnels ?

No, the file transfer is between 2 PC's, both connected on same SSID of WLC, but at a very slow rate.

 

For a small kb, it take around an hour.

Review Cisco Networking for a $25 gift card