snmp over cisco access point

[admin_2]

hi,

i 'm trinying to manage my cisco 1230 access point via snmp, and i want to know how can i access to the ip adresse of the device connected over , ifound the arp table but it doesn t reflect the exact status of the ip (if this station are connected or not)

can you help, it s very important for me , thank you in advance

[minie]

If I understand correctly, you want to the ip address of the switch the AP is connected to. Then you should poll cdpCacheEntry, oid .1.3.6.1.4.1.9.9.23.1.2.1.1

http://www.cisco.com/go/mibs

[#3]

hi,

thank you for your help but hat i really want it s the ip adresse of the laptop which are connected to the access point ( for example)

in which oid can i find this information? thank to tell because it s very very important

[Mark3000]

1/ try an snmpwalk -c "your community" "ip of your AP" and check if you are able to see the associated clients.

2/ I remember I have use mib called CISCO-DOT11-ASSOCIATION-MIB.my for AP12xx to granb some data related to client PC. Check out the mib on cisco mib navigator.

Good luck.

[#5]

thank you for your help,

i am able to check this mib but i didn't found what i want.

there is no field that specify the ip adress of the active device ( there is a mac adress but the data is contradictory with the iftable : this mac adress doesn 't exist in the iftable).

the ip adress of active device exists certainly in one of the cisco mib, so can you help me because it is very important for me.

thank you in advance