snmp traps will not stop

[MZydorczyk2]

We are getting a ton of snmp "cold start" traps. About every minute or less. I even took the statement out of the configuration to stop the device from sending those traps but they're still coming.

I used the "no snmp-server traps enable snmp coldstart warmstart"

I verified that it was no longer in the config as well. Any help?

[andrew.prince]

Is this for a specific interface? if so try "no snmp trap link-status" in the interface config.

HTH.

[MZydorczyk2]

These are coming from our wireless access points. We dont want to turn off all status traps on them either.

[Scott Fella]

Are your ap's bouncing? I have only seen this when the ap is on the secondary controller and fails to joins its primary.