SSH/Telnet to an AP from Cisco WLC CLI?

[nathant]

Hi Community,

Is it possible to SSH/Telnet to an Access Point (AP) via the Cisco Wireless LAN Controller (WLC) CLI?

I have performed a '?' at the '>' EXEC prompt and cannot see any valid options.

Regards,

Nathan.

[Sandeep Choudhary · Accepted solution]

Hi,

I dont recommand it but ....In a way, it is possible using "debug ap enable <AP name>" and then issue the commands by using "debug ap command <command in quote>".
Best way to just find out what is the IP address of the AP and then remote into the AP without the WLC because it is faster and less cumbersome.

Regards

Dont forget to arte helpful posts