SSID Monitoring ???

[Sakthi vel]

I want to Monitor the SSID which configured in WLC

Is there any tool or plugin available for WCS or else For nagios.

Please help me on this.

[Nitzbegin]

Hi Sakthi,

I dont think we can monitor SSID , As this is one of the entity/config through which the Wifi users will communicate inorder to access their network.

Also this is shown natively by the WCS (Users -> SSIDs). So there is not point in monitoring the SSID in specific if you have WCS in place,

Basically SSID's nothing but Configuration tat helps client devices distinguish between multiple wireless networks

So basically Multiple networks = Multiple SSID's

Thanks,

Nithin

[Amjad Abdullah]

What type of monitoring that you want?

on WCS I have a configuraiton to show me graphs of number of clients per SSID. Also you can set graphs for bandwidth consumption per SSID.

Is that what you are looking for?

Regards,

Amjad

Rating useful replies is more useful than saying "Thank you"

[Abhishek Abhishek]

Hello Sakthi,

As per your query i can suggest you the following solution-

To Monitor the SSID which configured in WLC

Monitoring the Status of Per-WLAN RADIUS Source Support

To see if the feature is enabled or disabled, enter the following command:

show wlan wlan-id

Example

The following example shows that the per-WLAN RADIUS source support is enabled on WLAN 1.

show wlan 1

For more information refer the link-

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70wlan.html#wp1432232

[Leo Laohoo]

I think I know what you are looking for ... If you have WLC, load firmware 7.4.100.X and enable AVC.