cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
423
Views
1
Helpful
1
Replies

Standalone AP no IP to users

lAhmed Saadl
Level 1
Level 1
Dear Experts,

We got a small setup with 6 standalone AP model 1142 with external DHCP server. AP connects SW -> FW -> Dhcp relay on FW -> DHCP server.

 

The issue is user get connected to that AP but with no IP assigned. we noticed that AP cannot provide IP address to users.

No dhcp lease time is configured.

If I connect a device to the same subnet as the wireless users, they got IP normally.

The wired and wireless using different subnets.

configs as below;


dot11 ssid testap
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii 7 P@ssw0rd

bridge irb


interface Dot11Radio0

encryption mode ciphers aes-ccm

ssid testap

no shu

interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
no keepalive
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
bridge 1 route ip

hostname AP1

enable secret P@ssw0rd

username admin privilege 15 secret P@ssw0rd

interface BVI1
ip address 10.23.11.10 255.255.255.0

ip default-gateway 10.23.11.1

ip http server

bridge irb

 

 

Appreciate your support

 

1 Reply 1

marce1000
Hall of Fame
Hall of Fame

 

           
          - Can't see the need for those bridge commands if you are doing pure standalone on the APs , anyway review this guide :
               https://www.cisco.com/c/en/us/td/docs/wireless/access_point/atnms-ap-8x/configuration/guide/cg-book.pdf

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card