Standalone AP no IP to users

[lAhmed Saadl]

Dear Experts,

We got a small setup with 6 standalone AP model 1142 with external DHCP server. AP connects SW -> FW -> Dhcp relay on FW -> DHCP server.

The issue is user get connected to that AP but with no IP assigned. we noticed that AP cannot provide IP address to users.

No dhcp lease time is configured.

If I connect a device to the same subnet as the wireless users, they got IP normally.

The wired and wireless using different subnets.

configs as below;

dot11 ssid testap
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii 7 P@ssw0rd

bridge irb


interface Dot11Radio0

encryption mode ciphers aes-ccm

ssid testap

no shu

interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
no keepalive
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
bridge 1 route ip

hostname AP1

enable secret P@ssw0rd

username admin privilege 15 secret P@ssw0rd

interface BVI1
ip address 10.23.11.10 255.255.255.0

ip default-gateway 10.23.11.1

ip http server

bridge irb

Appreciate your support

[marce1000]

           
          - Can't see the need for those bridge commands if you are doing pure standalone on the APs , anyway review this guide :
               https://www.cisco.com/c/en/us/td/docs/wireless/access_point/atnms-ap-8x/configuration/guide/cg-book.pdf

 M.