03-25-2020 12:14 AM - edited 07-05-2021 11:53 AM
Hi!
I have 5 WLAN Profiles configured on WLC.
AP's are registered to this WLC and configured in Flexconnect mode.
All 5 WLAN profiles are associated to management interface of WLC.
There are several AP groups configured on WLC .All 5 WLAN profiles are added to those AP groups and associated to management interface of WLC in AP groups.
In Flexconnect groups, WLAN to VLAN mapping has been done for clients to receive IP address from the respective VLANs.
Client authentications are happening and receiving IP addresses correctly.
My Question is - Has there been any bug reported in past about Flexconnect WLAN to VLAN mapping failure?...or due to some reasons if Flexconnect WLAN to VLAN mapping does not work, client traffic for all WLAN profiles will switch to default i.e. clients will get associated to management interface and thus will not be able to receive correct IP addresses from respective VLAN's.
Please suggest what should be better approach in terms of WLAN Profile to interface tagging when AP's are registered to WLC in flexconnect mode and WLAN to VLAN mapping is configured under Flexconnect group.
Thank you!
Regards
Nishant Jha
03-25-2020 01:20 AM
Hi Nishant,
Which controller model, AP model and software release are you using?
03-25-2020 02:56 AM
03-27-2020 07:56 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide