TFTP image to Cisco WLC 2504

[dougsmith1988]

I am trying to TFTP an image to a Cisco 2504 WLC. The management interface is 10.1.1.1 /24 and I have my PC connected to a port on the WLC with the IP address 10.1.1.10. However, I still do not have connectivity between the PC and WLC. Any advice?

[Tony Rosolek]

Are you able to ping the wlc?

Check the firewall settings on your device.

[Scott Fella]

If you are connected directly to the WLC, you need to make sure the management interface is untagged, set to '0'.

You really should be connecting the WLC to a switch since the WLC isn't really a switch and TAC doesn't support connecting devices like AP's or PCs to the WLC.

Sent from Cisco Technical Support iPhone App

[Saravanan Lakshmanan]

Try from service port.

If service port on same supernet as management then you may have this issue. change the subnet of service port in this case.