11-30-2012 12:47 PM - edited 07-03-2021 11:08 PM
I am trying to TFTP an image to a Cisco 2504 WLC. The management interface is 10.1.1.1 /24 and I have my PC connected to a port on the WLC with the IP address 10.1.1.10. However, I still do not have connectivity between the PC and WLC. Any advice?
11-30-2012 01:31 PM
Are you able to ping the wlc?
Check the firewall settings on your device.
11-30-2012 03:21 PM
If you are connected directly to the WLC, you need to make sure the management interface is untagged, set to '0'.
You really should be connecting the WLC to a switch since the WLC isn't really a switch and TAC doesn't support connecting devices like AP's or PCs to the WLC.
Sent from Cisco Technical Support iPhone App
11-30-2012 03:26 PM
Try from service port.
If service port on same supernet as management then you may have this issue. change the subnet of service port in this case.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide