Wireless

Hi all,Some of 'n' supported ap`s (3500 & 3600) registered to 5508 wlc, automatically shows down for 5Ghz and only b/g is up. Code of wlc is 7.4.100.60.What could be the reason..?

Hi All,We have created temporary wireless setup for our users in one floor with 13 APs. In which 9 of them 'n' supported AP's and remaining are only b/g.we have conducted proper wireless site survey and we have placed the AP according to that.  But t...

WLC code release notes say that 1.4.1 is required version of PI. It is not shown on TAC downloads.

Accidentaly disabled a wrong MAC address in WCS 7.0.230.0. Please help me to provide the acces again on network.i have tryed several times to REMOVE the client from the list, unfortunately nothing is worked. Salmasabeel

Has anyone ever had any issues with a UHF 2-way radio causing all wireless within a range to drop?i have a customer that has Kenwood 2-way radios in the warehouse TK-8360HUK & TK-3360, and whenever they key up the basestation to start a call, the pc ...

Has anyone here tested the roaming between Meraki MR APs across different L2 domains?I'd like to know...1) if it works now without the MX appliance,2) how it works (GRE tunnel etc)3) what the throughput is with the handoffThanks,Rogeliorogelio @ rnd ...

Hi all,I'm having some issue with upgrading from Prime 1.2.1.012 to 1.3.0.20I can only find upgrade information for version 1.2.1.12 is this the same version as 1.2.1.012?Until step 4/7 all seems to run ok but its skipping some steps in the process? ...

HiAs we are a NHS Hospital I've kept away from using Lobby Ambassador as we use a managed services to look after our guest access needs.Lobby Ambassador would help out for corporate visitors.My question is using Lobby Ambassador for non paying people...

What would be the proper way to mount APs, 3602E, if my requirements be that they are inside the ceiling and unseen by the end user. No type of external antennas must be visible. Existing APs are inside the ceiling (basically an attic space) with the...

Hi,how can I reset 1552 to factory default with console. I had mistake and install 1552 configured like ROOT AP and on the site I don't have a wire. Now I need to change AP mode to MESH AP becose AP join to wlc for some time and then disconect. I tri...

Hello,Can someone help me? I need help setting up a MESH topology as seen in the attached file.I've never configured a Mesh topology and I do not know where to start or even how it works and how troubleshoute?What are the best practices? knowing that...

Is there a way to make AP mode change to flexconnect / flexconnect vlan mappings to a group of AP's at the same time?

Hi,i was following cisco support community tread for how to chagne LAP1142N from LAP to Autonomous mode; was able to upload c1140-k9w7-tar.152-2.jb.tar to AP; AP boots with new image but i cannot access AP ove console port now. Any ideas would be app...