04-26-2012 07:22 AM - edited 07-03-2021 10:03 PM
Hello,
Situation:
Third-Party Tool (Whats up gold) has connectivity to a 5508 controller, only.
There is no connectivity to the remote LAP access-points from the third-party tool.
Is it possiply to get the health information (AP available or not) over a controller via SNMP?
Sven
Solved! Go to Solution.
04-26-2012 09:37 AM
Yes, there are MIBS that can be queried to get the AP status.
Steve
Sent from Cisco Technical Support iPhone App
04-26-2012 09:37 AM
Yes, there are MIBS that can be queried to get the AP status.
Steve
Sent from Cisco Technical Support iPhone App
04-26-2012 01:07 PM
Just to elaborate on what Steve is saying:
The SNMP monitoring of APs is still through the WLC itself. You would be pulling this information out of the WLC not via reachability to the AP itself from your tool.
Or you could use Whatsup for just an IP reachability (ping) of the AP which would require interaction with the WLC.
Can Whatsup be a trap receiver? I believe the WLC will send TRAPs for AP up/down events which I would think you could query off of.....
04-27-2012 01:22 AM
Can Whatsup be a trap receiver?
I never work with Whatup Gold before so I don't know, too.
I'll start a discussion with our local Whatsup Gold Administrator and check this part.
Thanks for your answer
Sven
04-27-2012 01:08 AM
Thank you for your answers, it confirm my presumption
Sven
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide