Wireless

Hi All,I have my main site (A) which hosts a WLC  and also has a local Internet breakout. Prime also runs at this site.I have Site B which is one of our remote sites that has an AP connected to it.I have the AP firmware all downloaded and can see it ...

I have a DHCP server on a WLAN that does not support Cisco's native proxy mode. I need to use DHCP bridge mode for that WLAN only.How do I disable DHCP Proxy and switch to DHCP bridge mode for one WLAN ?Thanks

Hi We are having some Issue with some Access Points are dropping clients on 2.4 GhZ radio, the radio is if you SSH to the Access Point "Dot11Radio0 is up, line protocol is up".Our setup is 2 x Wism2 controller (7.5), a CPI (1.4), and around 750 Acces...

Hi I would like to ask if I can block a user who connects to our network and generates high usage of internet. The problem is every time he clones his MAC address.PS ...( WITH OUT SETTING A PASSWORD ON THE APs AND WITH OUT SWITCHING THEM OFF)THX

I have a Cisco 5508 controller with multiple 3601-3602 APs. Is there a way to isolate clients by MAC address to a specific AP?

Hi, I was curious to know if there is a way to bulk edit our Mac Filter templates on NCS Prime 1.3? In the mac filter under controller template launch pad > Security > Mac Filtering we have several hundred templates for various devices. We are in nee...

Hi Team,I am using Cisco Prime Infra 2.0. I want to find the logs related to LWAP Templete. We have 4-5 templets created. few days back one templete has been modified and the templete was pushed to all the AP's. So i need to know when,How and Who has...

Started seeing this error message today.  Looking for what I can do to resolve this.  Running CPI 1.3                  

Dear AllCould any one tell me the step by step procedure of integrating MSE with prime..?And also what is the minimum version is required on Prime or dependencies if any.Thanks in advanceKVS

Hi,I have been offered a point-to-point configuration to extend our 2602i Wifi network.To replace an existing Psion Wifi connection (100 meters) consisting of 2 accespoints and 2 antenna's I'm offered the following:2x air-cap3502p-e-k96x air-ant2410y...

Hi,I have two ISE-3315 Appliances in production network. I need someone's help to explain, how to make the Secondary node as the primary admin note to reset-config.And then I would like to know how to keep the license files and Certificate during the...

hello everyoneI have an AP AIR-SAP1602E-E-K9 with ios 15.2(2)JB2, I have created several users via CLI with different privilege and can access with them through CLI without problems, but if try to log in via HTTP only users with level 15 can do it. O...

Hi all,I need hel pin configuring Bonjour on a 2504 controller with 7.5.102.0 fw.The controller is connected to a 2960S switch with 15.0(1)SE2.The antennas, all AIR-LAP1242AG-E-K9, are connected to this and other 2960 (same sw).I followed step by ste...

Hello all, I have multiple remote office locations and I have implemented HREAP using central authentication and local switching. The offices have 3 vlans. switch/router mngmnt, Wireless management and the office vlan. The access points are 3502I. Th...