Unable to access WLC 3504 GUI

[abdulhmalik]

Hi my wireless community!  I have 2 setups. One 3504 with LAG connected to a switch and one without LAG (single cable). On both I'm able to ping the WLC from the switch as well as management PC (statically assigned IP in the same subnet) but unable to access the GUI. I can ping the PC from the WLC as well as the switch.  I have configured the command : configure network webmode enable on both WLCs. I'm also able to SSH to both the 3504s.

One the one with the LAG - I have tried setting native VLAN to something other than the one tagged on the WLC. This has also not worked thus far. The 3504 without the LAG has the switchport set to access for the PC port

What else can I try to get access?  Any thoughts ?

Regards,

Abdul

[Mark Elsen]

 - Check if  the solving-reply in this thread can help you :

    https://community.cisco.com/t5/other-wireless-mobility-subjects/wlc-3504-can-t-connected-on-web-based-controller-after-setup/td-p/3779690

 M.

[abdulhmalik]

Yea I did try those already. It didn’t help me 

[Leo Laohoo]

Windows firewall?