Hi, I'm running into an issue where 2 of my APs seemed to have gone into FRA. I had enabled FRA just to change the DCA interval. Now I have turned FRA back off. However 2 of my APs seem to have got stuck in that FRA mode. I dont see their 2.4GHz radi...

Hi my wireless community!  I have 2 setups. One 3504 with LAG connected to a switch and one without LAG (single cable). On both I'm able to ping the WLC from the switch as well as management PC (statically assigned IP in the same subnet) but unable t...

Hi,   I was reviewing the "Cisco Wireless Controller Configuration Guide, Release 8.0". Under the Management of the WLC section , and more specifically the High Availability section , I found this below information in bold.    A redundancy VLAN shoul...

Hi. We have 2 x 5520 WLCs in our primary DC. We have configured them for AP SSO to minimize any downtime. We are looking to deploy a 3rd 5520 WLC to have kind of a tertiary backup to monitor the health of the WLCs in the primary DC. My question is I...

Hi all,Could you please help with the following issue? We were experiencing a lot of drops on the wireless network. We upgraded the firmware for the devices , but it didnt help. We upgraded the firmware (per TAC's recommendation abd it helped solve t...