WLC 3504 can't connected on web based controller after setup wizard

[Reedho]

i just bought a WLC 3504 device, after completion at the process setup wizard. then i can't enter the web based controller stage, with ip management that i have set. 

how can i enter this section.? for the switch i have set it to trunk mode

[Rasika Nayanajith · Accepted solution]

If you set a vlan for management interface in initial setting make sure it is not the native vlan on that trunk port.

with that you should be able to ping/GUI access the wlc.

HTH

Rasika

[Reedho]

I have successfully trunk the port, and can ping but still can't access the GUI, is there something wrong with my setup wizard?

[Scott Fella]

Console into the wlc and make sure you can ping the gateway from the appliance. You are also trying https correct.

[Rasika Nayanajith]

Did you try https://192.168.10.10 ?

If not try that

HTH

Rasika

[Reedho]

Solved

by changing the native vlan according to the existing trunk vlan and access https://ip address

Thanks @Rasika Nayanajith