02-02-2016 03:55 PM - edited 07-05-2021 04:34 AM
Good Day
I was hoping to find out if it is OK to upgrade 5508 Wireless Controllers in High Availabity mode when the normally secondary unit is ACTIVE and the primary unit is in HOT STANDBY mode.
The documentation says to push the upgrade to the ACTIVE unit but does not mention if that must be the primary unit.
Thanks in advance for any input
Regards
Amanda
02-02-2016 07:10 PM
Yes. The upgrade can be done on the active controller and the firmware will be automatically pushed down to the secondary controller.
02-03-2016 01:31 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide