cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1664
Views
20
Helpful
6
Replies
dporod
Beginner

User Idle Timeout

Is there a command that shows much time is remaining before a client will be removed due to the Contoller>User Idle Timeout (seconds) setting?

6 REPLIES 6
Flavio Miranda
Advisor

Hi 

  I dont know any command that show this information but in can see how long the client is connected  using show client detail <mac address>,

show client detail 00:...

Connected For ................................... 6994 secs

 

 

 

-If I helped you somehow, please, rate it as useful.-

 

Saravanan Lakshmanan
Cisco Employee

There is no direct way to find that detail before the fact. However, AP manages user-idle timeout for clients and can be found using the following command, use radio 0 for 2.4ghz.

AP#show controller dot11radio1 client
---Clients 0 AID VLAN Status:S/I/B/A Age TxQ-R(A) Mode Enc Key Rate Mask Tx Rx BVI Split-ACL Client-ACL WebAuth-ACL L2-ACL

d0d0.fd65.261f 5 6 30 40104 000 07E 299 0-0 (0) B398 200 0-10 00FFFFFF00000000000 020F 20F - - - - -

The value in the "Age" column (e.g. 299 in sec, in the above example) denotes the time in seconds till the user idle timeout expiry for this session.