08-22-2014 01:30 AM - edited 07-05-2021 01:25 AM
Hi Guys,
I've got a solution which i need to extend to a mobile cabin that is approx 15M from the main site. Is it possible to setup a WGB through the WLC with an IOS AP in the cabin that is then connected back to back to a lightweight unit to mirror the site setup ?
OR, is it possible to use 2 IOS APs for the bridge link and then back to back the lightweight unit?
Cheers,
Nick
08-22-2014 02:11 AM
HI Nick,
Yes its possible.
Check my latest post on this:
http://rscciew.wordpress.com/category/wgb-in-uwns/
http://rscciew.wordpress.com/2014/08/15/wgb-with-open-auth-in-uwns/
http://rscciew.wordpress.com/2014/08/15/wgb-with-wpa2-psk-in-uwns/
http://rscciew.wordpress.com/2014/08/15/wgb-with-multiple-vlan-in-uwns/
Hope it helps.
Regards
Dont forget to rate helpful posts
08-25-2014 08:34 AM
Hi Sandeep,
I've got those bits from previous deployments ;)
However, I can get the bridge established but for some reason, the AP plugged into the WGB does not want to join the WLC although I can both ping and see it in the DHCP options.
Basically, I want to connect a lightweight AP to the WGB in order to join the WGB and connect to the WLC.
Any ideas?
Cheers,
N
08-25-2014 08:55 AM
WGB is not showing in WLC client list ???
did you followed the post which i gave in my last reply?
Regards
08-25-2014 08:58 AM
Hi Sandeep,
The WGB is working fine. but the AP patched into it's ethernet port is not joining the WLC. I know connectivity is fine as the LWAPP AP can ping the WLC.
It's LWAPP > Wireless > WGB > Ethernet > LWAPP AP
Regards,
N
08-25-2014 09:03 AM
Yeah I got ur topology now.
I think it will not work and never tried.
Regards
08-25-2014 09:05 AM
I had a feeling that may be the case. I think a switch in between may negate this but again, it would need to be lab'd.
08-25-2014 09:06 AM
NO,i think even switch will also not help in this case.
Regards
08-25-2014 11:17 AM
Bridging an LWAPP AP over IOS works!
05-25-2018 10:24 AM - edited 05-25-2018 10:26 AM
I have this setup:
WLC>SWITCH>CAPWAP1>)))))(multiple VLANs)(((((WGB<SWITCH<CAPWAP2
The WBG associated just fine, the CAPWAP2 can ping the WLC, but wont associate, can this be done or is this a limitation due to the CAPWAP not support over the wireless link or something similar?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: