VERSION 29.4.1 no compatible with Catalyst (Legacy)

[wmendozaOpenlink]

Hello Last night at 8pm my MR44 did an update to version 29.4.1 and for some reason it is no longer compatible with my Catalyst (Legacy)

WS-C3560G-48PS 15.0(2)SE11
WS-C3750G-24PS 12.2(46)SE

I've rolled back to the point where I'm taking my MR44s to 28.5.1, but it's still having issues where they connect and disconnect every 5 minutes.

It is a very small network and I really don't understand what is happening, has anyone else had this problem?

I have also changed the port speeds from 100 to 1000 but it doesn't seem to solve the problem.

[CMR]

@wmendozaOpenlink we have plenty of MRs running 29.4.1 on Catalyst switches and do not have a problem. Ours are connected mainly to 3850s and 2960Xs. The only MR44 we have is however connected to a Meraki MS355X switch.

[aleabrahao]

How many Access Points do you have connected to these switches?

[aleabrahao]

Probably it's running on low power mode, right? Have you tried to perform a factory reset on APs?

[wmendozaOpenlink]

Hello everything is working fine and... again the AP is down...

I was working in normal mode, however I compared it with another of my APs and that is in low power mode and the result is still the same every 5 minutes the AP goes down, I am going to perform a rest.

This output is is where the AP connects---> Gi0/30 auto on 15.4 Ieee PD 4 15.4

I wanted to tell you that it does not turn off, it only disconnects from the network, but the interface is still up, I changed it from vlan and it is the same resolved, every so often the ap goes down, I am going to perform a rest

[CMR · Accepted solution]

You should see the AP model there, personally when I see IEEE PD for a Meraki AP it means something is wrong. Usually the cabling.