Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
My access points are unable to Join the Wireless controller. It looks like the following:Anyone have an idea how to fix this? Please help....
Hi. I recently mounted two CBW140AC-B AP. First one took three hours to "get" the ip, it was blinking green-red-orange. This means "Stage — 7 IP assigned and Capwap Init (If a Primary AP exists in network moves to stage 8 else switchdriver process st...
Does this bother anyone else? That there's an unnecessary indentation before the login banner on the web ui that isn't there in the CLI?I've been through about 5 different IOS versions and am now on the latest 17.12.3 and it's still there.banner logi...
I have WLC 2504 with v8.3.150.0 and I updated the OUI file from https://standards-oui.ieee.org/oui/oui.txt and the update was successful. I ran below commands, and it shows up the updated info. (Cisco Controller) >show profiling policy summaryNumber ...
I am trying to join CW9166 APs at a remote site to a C9800-CL WLC at the HQ site. A site-to-site tunnel between a Meraki MX67 (remote) and FTD-2110 (HQ) has been created. The WLC can reach the APs via ping; the MX can ping the WLC sourced from the AP...
Hi, all I am new to network IT and CIsco product. The C9115AXI-EWC-S was installed on the ceiling during renovation without configuration. the WAP is connected to Cisco 9300L PoE. After I tried to login to the CiscoAirProvision wifi and it prompts t...
Is there a way to enter the Wizard mode for Mobility express without having access to Console? I can access the devices using SSH I have already convert it to ME but its not broadcasting the CiscoAirProvision SSID any ideas?AP Image type : MOBILIT...
How do i setup, that two clients (laptop + surface) will be blocked from the WLAN during night (22:00 - 08:00).Other clients will be able to connect the WLAN all time.Thanks
Hi, we're in process to setup syslog server to received logs from our MR devices. We would preferably would have a centralized syslog, however because we have MR device at different locations, one point that was raise, is how would MR device handle a...
Resolved! 5417 Dynamic Authorization failed
Failure Reason: 11213 No response received from Network Access Device after sending a Dynamic Authorization request Hello friendsI have an ise VM 3.1.0.518, a 9800 VM controller 17.9.4a, with a guest user redirection page, everything works fine, the ...
Hello everybody, sb know, how to disable IPv6 (CLI) on WLC9800-40? SW 17.4.1 IOS-XE Bengaluru. GUI Global Config do not works. Thanks a lot.
Hello ,In 9800 environment, ap mode is flex is it possible to exclude a one client for a specific ssid.for ex: excluding the client for ssid (abc) but should be able to connect to xyz. Anjana
Hi guys, i am having a weird issue post upgrade of HA WLC 5520 from 8.1.102.0 to 8.5.164.0. The previous active unit is standby and current active box i do see APs associated. The problem is when i failover the WLC, the actual active unit unable to g...
We have an issue with the APs encountering EAPOL timeout at exactly 8 hours. The disconnection occurred at exactly 8 hours from the time the client successfully authenticated on the ISE functioning as a RADIUS server. Client laptop authenticated at J...
