Hi.
A catalyst 2950 has 3 vlans:
- Native VLAN 1 with no ports associated
- VLAN 4 for the users
- VLAN 5 for the network management (with VLAN 5 ip address 192.168.7.29/28)
I want replicate the same VLANS on the AP (1130AG): VLAN 4 for the users and VLAN 5 for AP management, but i would like to avoid to make native the vlan 5. It is possible to achieve this?
So far i configured the switch's FastEthernet as Trunk, carrying the VLAN 4 and 5, and on AP i've created interface FastEthernet0.4 and Dot11Radio0.4 for the VLAN 4.
interface FastEthernet0.4
encapsulation dot1Q 4
no ip route-cache
bridge-group 4
no bridge-group 4 source-learning
bridge-group 4 spanning-disabled
interface Dot11Radio0.4
encapsulation dot1Q 4
no ip route-cache
bridge-group 4
bridge-group 4 subscriber-loop-control
bridge-group 4 block-unknown-source
no bridge-group 4 source-learning
no bridge-group 4 unicast-flooding
bridge-group 4 spanning-disabled
For what concernes the VLAN 5, all i did is:
interface FastEthernet0.5
encapsulation dot1Q 5
no ip route-cache
interface BVI1
ip address 192.168.7.29 255.255.255.240
no ip route-cache
What else should i do, now?