cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
755
Views
0
Helpful
1
Replies

VTY line configuration on a 1042

theophile
Level 1
Level 1

Hello,

I'd like to know if there is any command to configure the vty line interfaces on the AP with the console cable so without going through the wlc. My point is to configure SSH and telnet on vty 0 to15. When I checked the matching box on the wlc, I see in the config:

line vty 0 4

   transport input all (instead of none)

But as it is a LAP, I don't have any 'conf t' or vty command.

Do you know how to?

Thanks

Theophile

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

That is a lightweight AP so you can't do that.  You first need to allow telenet and ssh on the AP once it joines the wlc and then you can set your login credentials.  The controller manages all the lightweight AP's so there is a limited amount of cammands that can be ran on the LAP's.

-Scott
*** Please rate helpful posts ***

View solution in original post

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

That is a lightweight AP so you can't do that.  You first need to allow telenet and ssh on the AP once it joines the wlc and then you can set your login credentials.  The controller manages all the lightweight AP's so there is a limited amount of cammands that can be ran on the LAP's.

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card